Study of Turbofan Engines Designed for Low Enery Consumption

Subsonic transport turbofan engine design and technology features which have promise of improving aircraft energy consumption are described. Task I addressed the selection and evaluation of features for the CF6 family of engines in current aircraft, and growth models of these aircraft. Task II involved cycle studies and the evaluation of technology features for advanced technology turbofans, consistent with initial service in 1985. Task III pursued the refined analysis of a specific design of an advanced technology turbofan engine selected as the result of Task II studies. In all of the above, the impact upon aircraft economics, as well as energy consumption, was evaluated. Task IV summarized recommendations for technology developments which would be necessary to achieve the improvements in energy consumption identified

Study of unconventional aircraft engines designed for low energy consumption

A study of unconventional engine cycle concepts, which may offer significantly lower energy consumption than conventional subsonic transport turbofans, is described herein. A number of unconventional engine concepts were identified and parametrically studied to determine their relative fuel-saving potential. Based on results from these studies, regenerative, geared, and variable-boost turbofans, and combinations thereof, were selected along with advanced turboprop cycles for further evaluation and refinement. Preliminary aerodynamic and mechanical designs of these unconventional engine configurations were conducted and mission performance was compared to a conventional, direct-drive turofan reference engine. Consideration is given to the unconventional concepts, and their state of readiness for application. Areas of needed technology advancement are identified

QCSEE task 2: Engine and installation preliminary design

High-bypass turbofan engines with features required for commercial short haul powered lift transports were designed. Two engines were configured for each of the externally blown flap installations, under-the-wing and over-the-wing. Estimates of installed and uninstalled performance, noise, and weight were defined for each propulsion system

Quiet engine program flight engine design study

The results are presented of a preliminary flight engine design study based on the Quiet Engine Program high-bypass, low-noise turbofan engines. Engine configurations, weight, noise characteristics, and performance over a range of flight conditions typical of a subsonic transport aircraft were considered. High and low tip speed engines in various acoustically treated nacelle configurations were included

Study of the costs and benefits of composite materials in advanced turbofan engines

Composite component designs were developed for a number of applicable engine parts and functions. The cost and weight of each detail component was determined and its effect on the total engine cost to the aircraft manufacturer was ascertained. The economic benefits of engine or nacelle composite or eutectic turbine alloy substitutions was then calculated. Two time periods of engine certification were considered for this investigation, namely 1979 and 1985. Two methods of applying composites to these engines were employed. The first method just considered replacing an existing metal part with a composite part with no other change to the engine. The other method involved major engine redesign so that more efficient composite designs could be employed. Utilization of polymeric composites wherever payoffs were available indicated that a total improvement in Direct Operating Cost (DOC) of 2.82 to 4.64 percent, depending on the engine considered, could be attained. In addition, the percent fuel saving ranged from 1.91 to 3.53 percent. The advantages of using advanced materials in the turbine are more difficult to quantify but could go as high as an improvement in DOC of 2.33 percent and a fuel savings of 2.62 percent. Typically, based on a fleet of one hundred aircraft, a percent savings in DOC represents a savings of four million dollars per year and a percent of fuel savings equals 23,000 cu m (7,000,000 gallons) per year

Energy efficient engine: Preliminary design and integration studies

Parametric design and mission evaluations of advanced turbofan configurations were conducted for future transport aircraft application. Economics, environmental suitability and fuel efficiency were investigated and compared with goals set by NASA. Of the candidate engines which included mixed- and separate-flow, direct-drive and geared configurations, an advanced mixed-flow direct-drive configuration was selected for further design and evaluation. All goals were judged to have been met except the acoustic goal. Also conducted was a performance risk analysis and a preliminary aerodynamic design of the 10 stage 23:1 pressure ratio compressor used in the study engines

Influência de compostos do pré-tratamento de biomassa florestal no crescimento de Saccharomyces cerevisiae JP1.

Resumo. Disponível online. MIPE

Finite element approximation of sparse parabolic control problems

We study the finite element approximation of an optimal control problem governed by a semilinear partial differential equation and whose objective function includes a term promoting space sparsity of the solutions. We prove existence of solution in the absence of control bound constraints and provide the adequate second order sufficient conditions to obtain error estimates. Full discretization of the problem is carried out, and the sparsity properties of the discrete solutions, as well as error estimates, are obtained.The first two authors were partially supported by the Spanish Ministerio de Economía y Competitividad under project MTM2014-57531-P

Feiras livres como alternativa de comercialização de produtos da agrofloresta.

Com a busca por alternativas comerciais socialmente justas como maneira de otimizar a comercialização de produtos provenientes de agricultura familiar, destaca se a venda direta através de feiras, livres, que permite acesso direto ao consumidor sem necessidade de intermediadores. O Grupo de Produtores Agroflorestais Gralha Azul, de Morretes-PR, iniciou plantios de agroflorestas agroecológicas em 2009, sendo formado, atualmente, por 12 famílias de agricultores. Há um ano, o Gralha Azul iniciou sua participação na Matinfeira, feira semanal de produtos da agricultura familiar em Matinhos, PR. Com o objetivo de caracterização dos produtos, produtores e do processo de comercialização, foram acompanhados e sistematizados em planilha a comercialização destes produtos em 22 feiras semanais, entre maio e dezembro de 2012. Onze produtores participaram da Matinfeira, comercializando entre 13 e 29 variedades de alimentos, e proporcionando uma renda que variou de R$101,00 a R$ 386,50, por semana. Mensalmente, as feiras permitiram uma receita bruta de R$ 141,17 por produtor familiar agroflorestal. Apesar desse baixo valor, há que se considerar que o mesmo reflete os primeiros seis meses de atuação do Grupo no processo de comercialização na feira (Matinfeira). A venda direta através desta feira livre mostra potencial como alternativa comercial socialmente justa para os produtores em transição agroecológica do Grupo Gralha Azul